Kee Klamp Fittings

The simple but effective engineering principle of the Kee Klamp fitting is the foundation of the most versatile pipe connection system available. There are many variations of fitting to suit wide-ranging applications, thus providing the versatility to achieve virtually any structural configuration.

Kee Klamp fittings are malleable iron castings manufactured to the requirements of ASTM A47-77-32510. A range of fittings to suit eight sizes of pipe is available. A simple hex key (99) is the only tool required to create a strong, rigid joint. A recessed set screw (97), tightened by the hex key, firmly locks the pipe into the fitting. Set screws are manufactured in case hardened steel and are protected against corrosion by Kee Koat II.

A Kee Klamp fitting (size 5 to 9) can support an axial load of *2000 lbs. per set screw with the set screw tightened to a torque of 29 lbs./ft. This is normally obtained when the set screw is fully tightened using a ratchet wrench.
(* rating includes a safety factor of 2:1)

Kee Klamp Handrail Specifications



Single Socket Tee (10)	Straight Coupling (14)	Elbow 90 degrees (15)
Adjustable Side Outlet Tee (19)	Side Outlet Elbow (20)	90 Degree Side Outlet Tee (21)
Three Socket Tee (25)	Two Socket Cross (26)	30 to 60 Degree Single Socket Tee (29)
Three Socket Cross (35)	Four Socket Cross (40)	Cross Over (45)
Single Swivel Socket (C50)	Double Swivel Socket (C51)	Extra Heavy Flange (60)
Flange Round (61)	Standard Railing Flange (62)	Wall Flange (68)
Rail Support (70)	Malleable Drive-In Plug (84)	Set Screws (97)
Hex Key (99)